Namestitev omrežnega vmesniškega modula Cisco Catalyst
Ta razdelek vsebuje informacije pred in med namestitvijo omrežnih vmesniških modulov Cisco Catalyst (NIM) na robnih platformah Cisco Catalyst serije 8200.
konecview omrežnega vmesniškega modula
The Cisco Catalyst Network Interface Module (NIM) is supported on Cisco Catalyst 8200 Series Edge Platforms.
These are the steps to install a NIM:
1. Poiščite režo NIM na sprednji plošči.
2. Loosen the screws to remove NIM blank cover.
3. Vstavite NIM v režo.
4. Privijte vijake, da pritrdite NIM v režo.
These are the steps to remove a NIM:
1. If the NIM is up and running, issue the following command to shut down the NIM gracefully before removing it:
hw-module subslot slot 0/2 stop
Previdnost If you do not shut down the NIM gracefully before removing it, the NIM card could get damaged.
2. Poiščite režo NIM na sprednji plošči.
3. Odvijte vijake, s katerimi je pritrjen NIM.
4. Previdno izvlecite NIM iz reže.
All module slots must have a module or blank installed for the product to work thermally and for safety purposes.
Za dodatne informacije glejte podatkovni list za platforme Cisco Catalyst 8200 Series Edge na spletni strani cisco.com, kjer je na voljo seznam podprtih modulov NIM na platformah.
Odstranitev in namestitev omrežnih vmesniških modulov
Keep the following tools and equipment while working with the Network Interface Modules (NIM)s:
- Križni izvijač številka 1 ali majhen ploščat izvijač
- Zapestni trak za zaščito pred ESD
Odstranite omrežni vmesniški modul
1. korak Shut down the electrical power to the slot in the device, turn off the electrical power to the device. Leave the power cable plugged-in to channel ESD voltages na tla.
2. korak Remove all network cables from the rear panel of the device. Using a number 1 Phillips screwdriver, loosen the captive screws on the network interface module.
3. korak Slide the network interface module out.
4. korak If you are not replacing the module, install a blank faceplate over the empty slot to ensure proper air flow.
Namestitev omrežnih vmesniških modulov Cisco Catalyst
1. korak Shut down the electrical power to the slot in the router by turning off the electrical power to the router. Leave the power cable plugged in to channel ESD voltages na tla.
2. korak Remove all network cables from the rear panel of the device.
3. korak Remove the blank faceplates installed over the network interface module slot that you intend to use.
Opomba Save blank faceplates for future use.
4. korak Align the module with the guides in the chassis walls or slot divider and slide it gently into the NIM slot on the device.
5. korak Push the module into place until you feel the edge connector seat securely into the connector on the router backplane. The module faceplate should contact the chassis rear panel.
6. korak Using a number 1 Phillips screwdriver, tighten the captive screws on the network interface module.
7. korak Connect the module to the network and re-enable the power to the slot in the device.
Namestitev omrežnega vmesniškega modula Cisco Catalyst
Dokumenti / Viri
 |
Omrežni vmesniški modul CISCO serije 8200 Catalyst [pdf] Uporabniški priročnik Serija 8200, omrežni vmesniški modul Catalyst serije 8200, omrežni vmesniški modul Catalyst, omrežni vmesniški modul, vmesniški modul |