Home » SKYDANCE » SKYDANCE E1-D Door Sensor Switch Instruction Manual 
SKYDANCE E1-D Door Sensor Switch 
Features
- Door sensor switch, connected directly to the low voltage LED strip.
- When the door open, or no obstacle ahead, the strip turn on gradually. When the door close, or obstacle ahead, the strip turn off gradually.
- Max 4A output current, max output power 96W@24V.
- Generally installed in the aluminum lamp strip housing.
- 3M paste in the bottom of the PCBA make easy installation and security.
- Low cost and high stability.
- Widely used in wardrobe lights.
Technical Parameters
| Input and Output |
| Input voltage |
12-24VDC |
| Output voltage |
12-24VDC |
| Output power |
Max. 48W@12V Max. 96W@24V |
| Sensor data |
| Detective distance |
10cm |
| Detevtive angle |
15-30 |
| Safety and EMC |
| EMC standard (EMC) |
ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4 |
| Safety standard(LVD) |
EN 62368-1:2020+A11:2020 |
| Certification |
CE,EMC,LVD |
| Warranty and Protection |
| Warranty |
5 years |
| Protection |
Reverse Polarity |
| Environment |
|
| Operation temperature |
Ta: -30OC ~ +55OC |
Dimension
Installation attention
- Cut a hole in size L7 x H5mm on the side of the aluminum profile.
- Put mini sensor switch into profiles when power is off, put the detector head to the hole, detector head should face to the objects.
- Pay attention to power input and LED output polarity.
Wiring Diagram
www.iskydance.pl
Documents / Resources
References
