Sjpzwcrl RC12 Remote Control For GoPro Hero 

The Basics

Connected to GoPro

Connected to smartphone

Back

Functions

1. Shutter/Video Button
   In camera control mode: Short press to take/record Long press and hold for 2 seconds to record with one click (in shutdown mode)
2. Power Button
   a. Long press to turn on/off. (3 seconds)
   b. Short press to switch camera main mode.
   c. In the recording state: short press to activate the Hilight marking function.
3. Sub-mode/Pairing Button
   a. When the camera is connected: short press to switch the camera sub-mode.(Can only switch the camera general sub-mode)
   b. Long Press for 3 seconds to enter the pairing state.
4. How to switch GoPro and smartphone remote mode:
   a. Default mode is GoPro mode, Long press and to switch to smartphone mode.(Repeat operation to return to GoPro mode)
   b. In smartphone mode, Search for the device with the name “RC10” on the Bluetooth of the mobile phone, after connecting and pairing, turn on the camera of the mobile phone, then can control the phone.

Paring GoPro

1. Power on remote control, the onnection signal flashes.
2. Power on GoPro: Swipe down » Swipe left» Connect »Connect Device
   Note: If you cannot connect for many times, you can restart the camera or reset the connection.

0ne to Multiple Modes

1. How to pare
   In the state of the first camera connected, long press the [pairing button 3 seconds remote control Bluetooth [indicator] flashing, you can connect the second camera and so on, the maximum number of connected 5 Go Pro cameras.
2. Notice
   a. The first connected GoPro status will be displayed on remote control screen only.
   b. After connecting multiple GoPro cameras, if the operation is turned off, except for the first GoPro, all other devices will be disconnected.
   c. The screen will display the number of connected cameras.

Specification

Battery Capacity	450mAh
Charging Port	TYPE-C
Input	5V1A
Charging Time	2.5h
Working Time	15h
Compatible with	GOPRO HERO 12/11/11Mini/10/9/8/MAX

Please charge with enclosed 5v cable only.

Wearing

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Documents / Resources

Sjpzwcrl RC12 Remote Control For GoPro Hero [pdf] User Manual RC12, RC12 Remote Control For GoPro Hero, Remote Control For GoPro Hero, Control For GoPro Hero, GoPro Hero, Hero

References

• User Manual