Size ly Printable Ring Instructions

Size ly Printable Ring

Specifications

• Product: Printable Ring Sizer
• Dimensions: Sizes & dimensions are approximate

Method A: Measure Your Finger

1. Cut out the ring sizer.
2. Cut a slit for Slot “A”.
3. Wrap the sizer around the finger where the ring will be worn. Make sure the numbers are facing out.
4. Pull the pointed end Tab “B” through Slot “A “until the sizer is snug. Make sure to allow size for your knuckle f your knuckles the is a size in between the two.
5. The number aligned with Slot “A” is your ring size.
6. If the measurement lands between two numbers, your size is a half size.

Example: If your measurement falls between 5 and 6, your ring size is 5 1/2.
Sizing Tip: Measure your finger at the beginning of the day to avoid incorrect measurements. More sizing mistakes are made by ordering rings too large rather than too small.

Method B: Measure a Ring that Fits

1. Select a ring that properly fits the intended finger.
2. Place the ring on top of the circle below until the inside edge of the ring matches the outside of the circle.

Comfort Fit Ring Tip: If the ring is a comfortable fit design, match circles to the contoured edge of the inner surface of the ring.

FAQs

Q: How can I ensure the ring sizer is printed correctly?
A: Measure the printed ring sizer with a ruler; it should measure 3 1/2 inches long from point A to point B.

Q: What if my knuckle size fa in between two numbers on the ring sizer?
A: If your knuckle size falls in between two numbers, it is recommended to choose the larger size for a more comfortable fit.