SIRHC-LABS-LOGO

SIRHC LABS Cortex EBC Complete Kit with Internal Display

SIRHC-LABS-Cortex-EBC-Complete-Kit-with-Internal-Display-PRO

WIRING

The 1988-1995 Mustang PCM is inside the vehicle, behind the kick panel in the passenger side foot well near the door. The PCM has a single large 60-pin connector. Power, ground, RPM, vehicle speed, and throttle position signals can be accessed at the PCM connector.

SIRHC-LABS-Cortex-EBC-Complete-Kit-with-Internal-Display-1

The Cortex EBC wiring harness and Speed Sensor Adapter V2 can be connected to the 60-pin PCM connector as outlined in the following tables. RPM and vehicle speed signals are required for boost by gear applications. The Speed Sensor Adapter V2 can be connected to the same power and ground source as the Cortex EBC if desired

CORTEX EBC TO PCM CONNECTIONS 

CORTEX SIGNAL CORTEX WIRE COLOR PCM SIGNAL PCM PIN PCM WIRE COLOR
+12V Power Red Switched PCM Power 37 Red
Ground Black (x2) Connect to Chassis Near EBC N/A N/A
 Engine Speed  Pink  Cam Position Signal (PIP)  56 Dark Blue Or Gray / Orange
 General-Purpose  Orange  Throttle Position  47 Dark Green/Light Green Or Gray/White

SPEED SENSOR ADAPTER V2 CONNECTIONS 

SPEED SENSOR ADAPTER V2

SIGNAL

SPEED SENSOR ADAPTER V2

WIRE COLOR

PCM SIGNAL PCM PIN PCM WIRE COLOR
 Sensor IN+  Green  VSS +  3 Dark Green / White Or Gray / Black
 Sensor IN-  Blue  VSS –  6 Orange / Yellow Or Pink / Orange
CORTEX SIGNAL CORTEX WIRE COLOR
Output White Vehicle Speed Green

VEHICLE CONFIGURATION SETTINGS

RPM DETECTION:

  • Pulses Per Cycle: 8
  • Rotations Per Cycle: 2

SIRHC-LABS-Cortex-EBC-Complete-Kit-with-Internal-Display-2

GEAR DETECTION:

  • Follow the steps in the Setup – Gear Detection section of the Help utility to determine the correct EVS ratio settings for gear detection.SIRHC-LABS-Cortex-EBC-Complete-Kit-with-Internal-Display-3

SPEED DETECTION:

  • Follow the steps in the Setup – Vehicle Speed Detection section of the Help utility to determine the correct Pulses Per Mile setting.
  • NOTE: Gear detection setup should be performed before calibrating the Pulses Per Mile setting.SIRHC-LABS-Cortex-EBC-Complete-Kit-with-Internal-Display-4

THROTTLE POSITION DETECTION:

  • Follow the steps in the Setup – Throttle Position Detection section of the Help utility to determine the correct Closed TPS Voltage and Open TPS Voltage settings.

SIRHC-LABS-Cortex-EBC-Complete-Kit-with-Internal-Display-5

Documents / Resources

SIRHC LABS Cortex EBC Complete Kit with Internal Display [pdf] Instructions
Cortex EBC Complete Kit with Internal Display, Cortex EBC, Complete Kit with Internal Display, Kit with Internal Display

References

Leave a comment

Your email address will not be published. Required fields are marked *