SimplyVAV STE-8001 Digital Wall Sensor
Use an STE-8001 or STE-8201 sensor to configure the SimplyVAV controller. If another type of sensor is installed as the room sensor, temporarily connect an STE-8001 as a service tool.
To get started
- Press the up and down buttons simultaneously to start configuration or balancing.
- Enter Password 2 if required. New installations do not have a password.
- Press the up and down buttons to move between functions or change values.
- Press the set point button to choose a selection or save a value
- CNFG The main configuration parameters for the VAV terminal unit.
- COMM Set BACnet device instance, MAC address, and network baud.
- BLNC Set airflow balancing parameters. Only the PRI (primary) menu is used for single duct
- VAVSTPT Enter temperature setpoints and limits.
- BOX Set up reheat, fan operation, and basic terminal unit functions.
- FLOW Set airflow setpoints and limits.
- ADVC Enter passwords and enable model specific features.
- RSTR Restore to factory settings
For complete details on controller configuration, browse to the KMC Controls website and download a PDF file of the SimplyVAV Application and Installation Guide. Not used for all models Select English (factory setting) or Metric before setting other parameters.
Documents / Resources
 |
SimplyVAV STE-8001 Digital Wall Sensor [pdf] User Guide STE-8001 Digital Wall Sensor, STE-8001, Digital Wall Sensor |
 |
SimplyVAV STE-8001 Digital Wall Sensor [pdf] Installation Guide STE-8001, Digital Wall Sensor, STE-8001 Digital Wall Sensor |
