NX Network Switch
User Guide
Package Contents
| NX 1 |  |
| Power Cable× 1 |  |
| LAN Cable× 1 |  |
| Quick Start Guide × 1 |  |
Product features
- Equipped with a newly developed power supply circuit ‘Silent Angel Power Module’ based on military radar standards.
- Wider spacing between LAN ports to reduce interference between terminals also allows thicker cables to be connected.
- RJ-, which has a high sound quality rating and minimizes the noise generated when receiving data
- Adopt port. Equipped with an external clock input pin. Silent Angel GX can provide a more accurate clock signal.
Connection example
Front panel
- Fuse holder
Contains one fuse.
Rear panel
- AC inlet
AC power indicator - Lights green when the power cable is connected and the power is on.
When you unplug the power cable, the indicator goes out and the power turns off. - DC power indicator
Lights green when external DC power is connected and power is on.
When the external DC power is removed, the indicator goes out and the power turns off. - DC input
Outer diameter 5.5mm
Inner diameter 2.5mm DC - Ground terminal
- Clock input pin
MHz clock input (BNC, Ω, square wave) clock selector - To use the external clock, slide the switch to “WORD CLOCK” and cycle power.
To use the internal clock, slide the switch to “INTERNAL CLOCK” and cycle power. - LAN port indicator switch
Toggles ON/OFF of the 8 LAN port status indicators. - LAN port status indicator
Blinks when network is connected and data is being sent or received.
– Blinks green when 1000Mbps communication on 8 port.
– Blinks in amber color when communicating at 100Mbps with 8 ports. - Gigabit Ethernet Port Mbps( BASE-T), Mbps(BASE-T).
If both DC and AC power are connected, the DC power will be used.
Documents / Resources
 |
SILENT ANGLE NX Network Switch [pdf] User Guide NX Network Switch, NX, Network Switch, Switch |
