Signify LLC7470 RF Mesh Node Instruction Manual

Signify-LOGO

Signify LLC7470 RF Mesh Node

Signify-LLC7470-RF-Mesh-Node-PRODUCT

Specifications

Dimensions 95.0 mm (3.74 in) height, 19.5 mm (0.77 in) connector length
Weight 0.245 kg
IP Rating IP66
Voltage 120-240 V, 50/60 Hz
Temperature Range -30°C to +25°C

Signify-LLC7470-RF-Mesh-Node- (1)

Weight Distribution

Signify-LLC7470-RF-Mesh-Node- (5)

Installation Steps

Signify-LLC7470-RF-Mesh-Node- (2) Signify-LLC7470-RF-Mesh-Node- (3)

Signify-LLC7470-RF-Mesh-Node- (4)

Signify-LLC7470-RF-Mesh-Node- (5)

  • Must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
  • Make sure power is OFF
  • Note
    There shall be an external fuse or MCB in the Line connection with a current rating of 16A or less.
  • Note
    RF node can only be used in overvoltage category II environment classified as IT equipment.

Compliance
Hereby, Signify declares that the radio equipment type LLC7470 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: www.signify.com/red 

Warning Do not use any chemical cleaning agents on the LLC7470.

© 2021-2025 Signify Holding. All rights reserved. The information provided herein is subject to change, without notice. Signify does not give any representation or warranty as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance thereon. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract, unless otherwise agreed by Signify. All trademarks are owned by Signify Holding or their respective owners.

UK importer address:
Signify Commercial UK Limited 2 Guildford Business Park GU2 8XG, UK www.signify.com/products

Frequently Asked Questions

Can the LLC7470 be used in all environments?

No, the RF node should only be used in overvoltage category II environments classified as IT equipment.

What should I do before starting the installation?

Make sure the power is OFF before proceeding with the installation process.

Are there any specific wiring instructions for connecting the Driver Mains?

Yes, connect the Red wire to Lo (Line out), White wire to N (Neutral), and Black wire to L (Line).

Documents / Resources

PDF thumbnailLLC7470 RF Mesh Node
Instruction Manual · LLC7470, LLC7470 RF Mesh Node, LLC7470, RF Mesh Node, Mesh Node, Node

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.