NUGGET II FLASH
MOUNTING
Do not cover the rear light!
Mounting height between 250 -1200 mm.
CE INFORMATION
SIGMA-ELEKTRO GmbH hereby declares that the NUGGET II FLASH complies with the fundamental requirements and other relevant regulations of Directive 2014/30/EU and RoHS Directive 2011/65/EU. You can find the CE declaration at: ce.sigmasport.com/nuggetllflash
ALIGNMENT
Final side of the tail lamp perpendicular to the roadway and at right angles to the vehicle center axis.
BATTERY INDICATOR
The battery needs to be charged immediately if the monitoring device/red indicator has been activated. The LEDs are not replaceable. If an LED fails, replace the tail light.
CHARGING
Please always keep the silicone plug closed after charging.
Energy extraction through the Micro USB port is not possible. These lamp needs to be replaced in case of defective light source.
During charging, the battery monitoring system lights up.
If the battery is ready for use again, both indicators will go out after charging.
ACCESSORIES
Ref. No. 18552
Charger +
Charging cable Micro-USB
Ref. No. 18553
Charging cable Micro-USB
Ref. No. 00468
O-ring bracket
sigma.bike
SIGMA-ELEKTRO GmbH
Dr.-Julius-Leber-Straße 15
67433 Neustadt/Wstr. Germany
service@sigma.bike
Documents / Resources
 |
SIGMA 18552 Nugget II Flash Taillight [pdf] Instruction Manual 18552, 18553, 00468, 18552 Nugget II Flash Taillight, 18552, Nugget II Flash Taillight, Flash Taillight, Taillight |
