SIEMENS DB-11 Base Detector Lock

INSTALLATION PROCEDURE

1. Use the hex tool provided with the SIEMENS Model LK-11 to install the set screw into the hole in the cover of the detector. (Refer to Figure 1.)
2. To lock the detector in the DB-11 base, rotate the hex tool clockwise until the set screw is flush with the detector cover flange and the top of the screw extends into the DB-11 base locking hole, as shown in Figure 2.

REMOVAL PROCEDURE

1. To unlock the detector in the DB-11 base, use the hex tool provided to rotate the set screw counter-clockwise until it no longer extends into the detector base and backs out approximately 1/4 inch from the detector cover flange. (Refer to Figure 3.)
2. Remove the detector.

Siemens Building Technologies, Inc.
8 Fernwood Road Florham Park, New Jersey 07932

Siemens Building Technologies, Ltd.
2 Kenview Boulevard Brampton, Ontario L6T 5E4 CN

firealarmresources.com

Documents / Resources

SIEMENS DB-11 Base Detector Lock [pdf] Instruction Manual K-11, DB-11, DB-11 Base Detector Lock, Base Detector Lock, Detector Lock, Lock

References

• User Manual