SIEMENS BT300-KEYPAD Panel Adapter Kit Instruction
Panel Adapter Kit – Mounting Instructions
Introduction
The Panel Adapter is intended to replace the standard keypad in cases where keypad is not needed.The Pan-el Adapter is Type 12/IP54 protected.
For the installation, you need the following parts included in the delivery. Make sure that you have received all necessary parts!
- Cover A
- Cover B
- Screws PT3.5 x 8 (4 pcs)
- Foam rubber gasket
Indication LED
The LED on the Panel adapter gives indications about the status of the drive. Note the location of the LED in picture to the right.
| LED indication | Meaning |
| Blinking slow (1 s ON – 1 s OFF) | Drive works normally (software running) |
| Blinking fast | Software is loading |
Mounting procedure
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as design improve-ments are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.
© 2013 Siemens Industry, Inc.
Siemens Industry, Inc. Building Technologies Division 1000 Deerfield Parkway Buffalo Grove, IL 60089-4513 USA
1-847-215-1000
Your feedback is important to us. If you have comments about this document, please send them to sbt_technical.editor.us.sbt@siemens.com.
Documents / Resources
 |
SIEMENS BT300-KEYPAD Panel Adapter Kit [pdf] Instruction Manual BT300-KEYPAD Panel Adapter Kit, BT300-KEYPAD, Panel Adapter Kit, Adapter Kit, Kit |
