shopify S2004 POS - logoS2004 POS Tablet
Instructions
Holdshopify S2004 POS - icon the button until the device turns on
help.shopify.com

Place tablet into stand Lock tablet to stand Plug payment terminal into tablet
shopify S2004 POS - figure 3 shopify S2004 POS - figure 2 shopify S2004 POS - figure 1

shopify S2004 POS - recycleThis box has been made with 100% recycled materials.

Shopify and the S Bag Logo are the registered trademarks of Shopify Inc. All other trademarks and brands are the property of their respective owners. For warranty and legal terms, visit shopify.com/legal/terms. © 2021 Shopify Inc.

Designed in Canada
Assembled in Thailand shopify S2004 POS - disposal

FCC Statement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (SAR) :
This device has been tested FCC SAR and meets the FCC SAR limit .
This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate or SAR. The SAR limit set by the FCC is 1.6 W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.  when worn on the body, as described in this user guide, is 1.41W/kg (Body-worn measurements differ among devices, depending upon available enhancements and FCC requirements.) While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement. The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID: 2AY2DS2004.
For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and positions the handset a minimum of 0 cm from the body. The use of other enhancements may not ensure compliance with FCC RF exposure guidelines. If you do not use a body-worn accessory, position the handset a minimum of 0 cm from your body, when the device is switched on at its highest certified power level in all tested frequency bands.

shopify S2004 POS - icon 2S2004

Documents / Resources

shopify S2004 POS Tablet [pdf] Instructions
S2004, 2AY2DS2004, S2004, POS Tablet

References

Leave a comment

Your email address will not be published. Required fields are marked *