ShieldPro Flood Temperature Sensor
The ShieldPro Flood/Temperature sensor installs easily in areas where water damage is a risk-like under sinks or in basements.
The sensor notifies you when it detects water or extreme temperatures.
What Comes In The Box?
- Flood/Temperature sensor x 1
Flood/temperature Figures
- Figure 1: Flood/Temperature sensor topside
- Figure 2: Flood/Temperature sensor underside
- Figure 3: Sensor under a sink
Placement tips
- Place on a flat surface with the underside facing the floor. No mounting brackets or screws required.
- Water detection: Place in areas prone to leakage and where water is most likely to pool.
- Extreme temperature detection: Place in areas where temperatures may reach below 41°F or above 95°F.
- You can enable or disable any of the sensor’s modes from the panel.
Install your Flood/Temperature sensor
Step 1 Pair sensor with the panel. Settings ( 
button) > Devices > + > Select Water > Follow the panel’s instructions to pair your sensor.
Step 2 Follow the panel’s setup prompts to name and assign your sensor to a location.
Step 3 Place your paired sensor as desired.
Customer Support
Questions?
Contact us at 1-800-574-7798 or CST@shieldpro.com
Documents / Resources
 |
ShieldPro Flood Temperature Sensor [pdf] User Guide Flood Temperature Sensor, Temperature Sensor, Sensor |
