Shenzhen X5 Projector Owner’s Manual

 

Thank you for purchasing this product. Please read this manual carefully before using it and keep it in a safe place.

 

Client downloading

 

Add device

1. Open the “v720” app and click “+” in the upper right corner of the page to start the binding process.
2. Select or enter the WiFi account you want to use and fill in the password.

 

3. Turn on and reset the device according to the page the blue indicator flashes quickly.

4. Wait until the device is bound successfully, and then the blue indicator is always on. (Tip: when you are connecting, please ensure that the network is unblocked,and the camera is turned on normally, the blue indicator flashes quickly at this time. After the connection is successful, the indicator light is steady blue.)

 

AP mode

1.Mobile phone turn on the WIFI and connect to the WIFI hotspo0″NAX_”.

 

2. Return to the “v720” app and refresh dropdownlist, when the device displays that means the short-range mode connection is successful.

 

 

Matters needing attention

1. The applicable working temperature of this product is -10°C~50°C. Please do not use this product in an environment where the temperature is too high or too low.
2. This product is a precision electronic product. Please do not use this product in an environment where is excessively wet or may cause water to enter the product.
3. To better use this product，please avoid the front and side of the lens close to the glass, white wall and other reflective objects, in order to avoid the picture is bright near and dark in the distance or whitish.
4. Please ensure that this product is installed within the range of Wi-Fi signal coverage, and placed as far as possible in a location with better Wi-Fi signal, and try to install it far away from the microwave oven or other locations that may affect the signal.

 

Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different. from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter

RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter

 

Read More About This Manual & Download PDF:

Documents / Resources

Shenzhen X5 Projector [pdf] Owner's Manual 2BCLC-X5, 2BCLCX5, x5, X5 Projector, X5, Projector

References

• User Manual