Shenzhen X10C Helmet Bluetooth Headset
Product overview
Important Notice
- Before installing the headphones, follow the Quick Manual instructions to connect your phone and listen to the sound and volume.
- If there is a large difference in sound effect and volume after installing it on the helmet, please adjust the position of the speaker in the helmet.
Phone features
Charging mode
List of items
Notes
- Do not put the product into the open flame to avoid explosion;
- Do not disassemble the product. Avoid damage to product electronics;
- Do not approach the sharp object, the object will cause damage to the product;
- Do not use for a long time, please place in a dry place.
Power on/off
Power on
Power off
Music features
Pause/play music
Switch music
Pairing
Turn On/off/voice assistant
FCC STATEMENT
instruction warning
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no quarantee that interference will not occur in a particular installation. This equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
- this device may not cause harmful interference. and
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in a portable exposure condition without restriction.
Documents / Resources
 |
Shenzhen X10C Helmet Bluetooth Headset [pdf] Instruction Manual X10C Helmet Bluetooth Headset, X10C, Helmet Bluetooth Headset, Bluetooth Headset, Headset |
