S1PRO Auto Proximity Switch
Product Information
Specifications:
- Product Name: Auto Proximity Switch
- Compliance: FCC Part 15
- Conditions: Must not cause harmful interference; Must accept
any received interference
Product Usage Instructions
Installation:
- Ensure the device is placed in a location with adequate
proximity to the intended objects. - Connect the auto proximity switch to a power source using the
provided cable. - Follow any specific installation guidelines provided in the
user manual.
Operation:
- Turn on the device using the power switch.
- Adjust the sensitivity settings if available to suit your
needs. - The device will automatically detect proximity to objects
within its range.
FAQ – Frequently Asked Questions
Q: What should I do if the device is causing interference?
A: If you experience interference issues, try adjusting the
placement of the device or its sensitivity settings. Ensure it is
not in close proximity to other electronic devices.
Q: Can I modify the device?
A: Any changes or modifications not approved by the responsible
party could void your authority to operate the equipment. Contact
customer support for guidance on modifications.
Auto proximity switch
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure statement The device has been evaluatec to meel general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
Shenzhen S1PRO Auto Proximity Switch [pdf] User Manual 2BRMB-S1PRO, 2BRMBS1PRO, S1PRO Auto Proximity Switch, S1PRO, Auto Proximity Switch, Proximity Switch, Switch |