Shenzhen FT1212A REMOTE CONTROL TRANSMITTER User Manual

Operation Instructions

1. Fan off
   • When operating, press the key to stop the fan.
   • This key for the fan off only.
2. Speed of the fan (1~6 level)
   • Press the key ”1,2,3,4,5,6” to turn on the fan to designated speed level.
   • After press speed level Keys, the fan will enter the corresponding speed level from other speed level or idle.
   • Key “1” is the lowest speed, and key”6 “is the highest speed.
3. Direction of the fan
   • Press the key can change the running direction of the fan
4. The other optional functions as below:
   • Light on or off.
   • + Turn up the brightness of the light.
   • _ Turn down the brightness of the light.
   • Adjust the color temperature of the light
5. The transmitter use 1pcs of 12V 23A battery, please install the battery correctly.

Use precautions

1. When press the key of transmitter, the LED indicator doesn’t on, please inspect the battery installation.
2. When press the key of transmitter, the LED indicator flashing, that means the battery get low voltage, please replace a new one.
3. Please pull out of the battery from the transmitter when leaving unused for a long time.

FCC Instructions

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Thisdevice complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause Undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.

IC Notice：

In addition to containing other required statements specified elsewhere in this standard or in the applicable RSS, user manuals for licence-exempt radio apparatus shall contain the following text, or an equivalent notice, that shall be displayed in a conspicuous location, either in the user manual or on the device, or both:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Documents / Resources

Shenzhen FT1212A REMOTE CONTROL TRANSMITTER [pdf] User Manual FT1212A REMOTE CONTROL TRANSMITTER, REMOTE CONTROL TRANSMITTER, CONTROL TRANSMITTER

References

• User Manual