CP04 AI Adapter
Specifications:
- 5G ready
- Supports 802.11 a/n/ac/ax standards
Product Usage Instructions:
1. Connecting to a Network:
To connect the device to a network, ensure that the network
supports 5G and is compatible with 802.11 a/n/ac/ax standards.
Follow these steps:
- Power on the device.
- Go to the settings menu on the device.
- Select the network option.
- Choose the 5G network from the available options.
- Enter the network password if prompted.
- Once connected, you can start using the device on the
network.
2. Maximizing Performance:
To get the best performance out of the device, consider the
following tips:
- Place the device in an area with strong network coverage.
- Avoid interference from other electronic devices.
- Regularly update the device firmware for optimal
performance.
3. Troubleshooting:
If you encounter any issues with the device’s network
connectivity, try these steps:
- Restart the device and try reconnecting to the network.
- Check if other devices can connect to the network to rule out
network issues. - Reset the network settings on the device and set up the
connection again.
Frequently Asked Questions (FAQ):
Q: What should I do if I cannot see the 5G network?
A: Make sure that your device is within range
of a 5G network and that the network is broadcasting its SSID. You
may need to move closer to the router or check the router settings
to enable SSID broadcast.
Q: Is it necessary to update the device firmware
regularly?
A: Updating the device firmware is recommended
to ensure optimal performance, security, and compatibility with the
latest technologies. It is advisable to check for updates
periodically.
5G, 802.11 a/n/ac/ax ready
FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Documents / Resources
 |
Shenzhen CP04 AI Adapter [pdf] User Manual 2BAUM-CP0002, 2BAUMCP0002, cp0002, CP04 AI Adapter, CP04, AI Adapter, Adapter |