Shenzhen Sperll Optoelectronic Technology SP108E WiFIi LED Controller

Features

1. Long distance APP remote control via WIFI;
2. Support routing mode(AP) and LAN connection mode(STA);
3. Support almost every kind of one-wire or two-wires LED driver IC ;
4. Brightness adjustable, With 180 kinds of patterns and 8 kinds of color adjustable patterns;
5. Creatively using from-image-to-effect method for user to DIY any effect;
6. Support setting pixel number and segments number, able to control up to 2048 pixels;
7. DC5V~24V wide range working voltage, reverse power supply input protection;
8. User setting saving;

App control

Both IOS version and Android OS version are available. (hardware should support WIFI)

• Requires IOS version 10.0 or later;
• Requires Android OS version 4.4 or later;
• Search”LedShop”in App Store or Google pay or scan this QR code to download and install the App:

Specifications

• Working temperature: -20℃~60℃;
• Working Voltage: DC5V~24V;
• Working Current: 20mA~130mA;
• Remote distance: 30 Meters;
• Product size: 85mm*45mm*22mm;
• Product weight: 40g ;
• Certificates: CE, RoHS;

Working Mode and Connecting

• AP(Access Point) mode: Controller and Phone connect directly, controller works as an access point.

Connect steps: 

1. When the device is not connected to any WIFI network, power on the controller and wait for 20s and then controller will switch into AP mode ;
2. In the WIFI setting page,find and connect the controller(named like SP108E_xxx, the default pin code is 12345678),
3. Open the LED Shop App ,then the controller will be showed on the device list;

• STA(Station) mode: Controller and phone are in one same WIFI network, in this network, users can operate the controller smoothly.

Connect steps:

1. When the device is not connected to any WIFI network,power on the controller, controller will be remain in Wait-For-Connet mode for 20 seconds;
2. Make sure that your phone is connected to a WIFI network, Open LED Shop APP, pressing the Add Device button, input the WIFI pin code, then press the OK to confirm and wait for the configure processing finish;
3. When controller successfully enter the WIFI network, it will be showed on the device list;
4. User can select the controller and remove it out of the network by pressing the Remove Device button, then the controller will switch into AP mode.

Wire Connection

Documents / Resources

Shenzhen Sperll Optoelectronic Technology SP108E WiFIi LED Controller [pdf] Instruction Manual SP108E, 2ATV8SP108E, SP108E WiFIi LED Controller, WiFIi LED Controller

References

• User Manual