Pro 3EM 3 Phase Energy Meter and Contactor Control
Product Information
Specifications:
- Product Name: Venus with Shelly Pro 3 EM
- Compatibility: Shelly Pro 3 EM, Venus
- Network: Wi-Fi
- Port Number: RPC over UDP – 2220 or 1010
Product Usage Instructions
Step 1:
Ensure that both Shelly Pro 3EM and Venus are connected to the
same Wi-Fi network with a strong signal.
Step 2:
Open the Shelly APP and set the ‘RPC over UDP’ port number to
‘2220’ or ‘1010’ on the specified page.
Step 3:
In the Marstek APP, select the meter type as Shelly Pro 3EM.
Step 4:
Verify the connection success by checking Venus’ LEDs or using
the Marstek APP.
FAQ
Q: What should I do if the connection fails?
A: If the connection fails, try restarting both devices and
ensure they are still on the same Wi-Fi network. Check the port
settings in the Shelly APP and retry the connection process.
Instructions for using Venus with Shelly Pro 3 EM
Step 1: Shelly Pro 3EM and Venus are on the same wifi, and make sure both devices have a good network signal. Step 2: Set the`RPC over UDP’port number on this page of Shelly APP to`2220′ or `1010′ .
Step 3: Select the meter type as Shelly Pro 3EM via Marstek APP.
Step 4: Check if the connection is successful via Venus’ LEDs or Marstek APP
Anleitung zur Verwendung von Venus mit Shelly Pro 3 EM
Schritt 1: Shelly Pro 3EM und Venus sind mit demselben WLAN verbunden, und stellen Sie sicher, dass beide Geräte ein gutes Netzwerksignal haben. Schritt 2: Setzen Sie die Portnummer ,,RPC over UDP” auf dieser Seite der Shelly APP auf ,,2220″ or `1010′.
Schritt 3: Wählen Sie den Messgerätetyp Shelly Pro 3EM über die Marstek APP aus.
Schritt 4: Prüfen Sie die erfolgreiche Verbindung über die LED des Venus oder die Marstek APP
Documents / Resources
 |
Shelly Pro 3EM 3 Phase Energy Meter and Contactor Control [pdf] Instructions Pro 3EM, Pro 3EM 3 Phase Energy Meter and Contactor Control, 3 Phase Energy Meter and Contactor Control, Energy Meter and Contactor Control, Contactor Control |