SHELL LAMP Z6 Speaker
Product Specification
- Product Name: Shell Lamp Speaker Product Model: Z6
- Product Material: PC+ABS
- Signal-to-noise ratio: >80dB Response
- Frequency:200Hz-20KHz Bluetooth
- Version:vS.3
- Rated Voltage:3.7V
- Audio Power:3W
Specially 7 types of lamps
Featuring 7 built-in white noise tracks
Function Description
BT Connection
- Turn on the device;
- Search for the device with the name “Z6” in the BT interface to connect; after connecting successfully, the product will play a beep.
Charge the battery
Charging state, indicator light red light; full, indicator light green light
Function Description
Volume Button
Short press: In music or white noise mode, “+” switches to the previous track; “-” switches to the next track Long press: In music or white noise mode, “+” increases the volume; “” decreases the volume
Light Mode Switch Button
- Short Press: Turn off the light in light mode. Press again to turn the light back on. (Seven light modes available).
- Long Press: Adjusts the brightness of the light gradually
Music Mode Switch Button
- Short press: Switches from music mode to white noise mode and plays the last selected white noise.
- Long press: clear the current BT connection – can reconnect to a new
Parts List
- Shell Speaker (With Wave light)
- Charging Cable
Product Safety Guidelines & Precautions
Before use, please read this manual carefully and follow the instructions.
- Put the speaker in a stable and safe place to avoid damage or injury by falling.
- Maintain adequate space around the speaker for optimal sound performance.
- Do not stick any foreign matter into the mesh or charging port of the speaker. Do not hit the speaker hard or with other external force.
- Keep away from heat sources, do not go near open flames, microwave ovens, electric heaters, and other high-heat electrical appliances. To ensure safety, use the attached accessories only.
- If you have any problems, please contact the original factory or agents to consult professional maintenance personnel.
Note: This product is only for people over 18 years old.
FCC STATEMENT
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired\ operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable devices:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Documents / Resources
 |
SHELL LAMP Z6 Speaker [pdf] User Manual 2BG5J-Z6, 2BG5JZ6, z6, Z6 Speaker, Z6, Speaker |
