Specifications:
- Product Name: Remote Control（RGB）
- Product Model: 058-6
- Electrical Parameters:
- Current: 15mA
- Voltage: 3V
- Power: 0.045W
Product Usage Instructions
Remote Control (RGB)
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
- The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
FAQs
Q: Can the remote control be used with multiple devices?
A: Yes, the remote control can typically be programmed to work with multiple devices as long as they are compatible.
Q: How do I change the batteries in the remote control?
A: To change the batteries, locate the battery compartment on the back of the remote, remove the old batteries, and insert new ones following the correct polarity.
Documents / Resources
 |
SHareconn 058-6 RGB Remote Control [pdf] Owner's Manual 2BCON-058-6, 2BCON0586, 058 6, 058-6 RGB Remote Control, 058-6, RGB Remote Control, Remote Control, Control, Remote |