Sewosy PBAL1 Surface Push Button With LED Installation Guide
TECHNICAL SPECIFICATIONS
General specifications
- Operating voltage : 12-24V DC +/- 10 %
- Consumption : max. 13 mA
- Switching capacity of the changeover contact by relay (C/NO/NC) : 30V DC – 0,5 A
- LED colour at switched state : Verte / Green
- Pluggable screw terminal block
- Conductor’s cross-section : max. 1,5 mm²
- IP rating : IP 20
- Operating temperature : -10 + 55°C
- Weight : 0,125 kg
DIMENSION
MOUNTING
Mounting with flush-box
Mortice mounting possible with standard 60 mm outlet box (not provided – recommended depth = 50 mm)
surface mounting
Screws and wall plugs are not provided
CONNECTION
Conductor’s cross-section : max. 1,5 mm²
Operating
EXT : Commanded extern de pilotage des LEDs
External control of the LEDs
- 12V DC
- 24V DC
- INT
Stand-alone mode
- EXT
External control mode
CONNECTION EXAMPLE
If the time delay function of the keypad is activated, the LEDs of the push button refer to the keypad time
delay status
Connection example: Fail secure operating
Attention
Caution
- Use correct input voltage as specified.
Wrong input voltage may damage the product. This failure is not covered by the product warranty
Documents / Resources
 |
Sewosy PBAL1 Surface Push Button With LED [pdf] Installation Guide PBAL1 Surface Push Button With LED, PBAL1, Surface Push Button With LED, Push Button With LED, Button With LED, LED |
