SERVER 07794 Express Replacement Pump User Guide

SERVER 07794 Express Replacement Pump

Tips and tricks to help you get started with your new Server Express pump

1. Remove unit from box. Wash, rinse, sanitize, and air dry pump parts properly before use.
2. Squeeze pinch valve open to ensure it isn’t stuck shut, then insert into pump housing.
3. Press dome into housing fully and wrap loop around lower opening to secure.
4. Lubricate with a small amount of clean water and install tube by rotating until both pegs on housing fit into holes on tube.
5. Lubricate with water and install connector by rotating until both pegs on connector fit into holes on tube.
6. Insert discharge fitting into discharge tube. Place loop of fitting around peg on end of discharge tube.
7. Fully assembled pump.

WANT TO LEARN MORE
Visit server-products.com/manual-more for your manual, part breakdown, support videos and more. spsales@server-products.com | 800.558.8722