SERAX B1924014-001 Table Lamp Instruction Manual

Contents hide

TYPE	COLOR	MATERIAL	DIMENSIONS
Table Lamp	White	Fine Bone China	L18.3 x W15 x H25.5 cm / L7.2 x W5.91 x H10.04 inch

MOUNTING INSTRUCTION MANUAL B1924014-001

installing or using this product and keep this user manual for further reference.

The luminaires may only be installed by authorized and qualified technicians according to the valid regulations for electrical installation.
Maintenance of the luminaires is limited to their surfaces. During maintenance, no moisture can come into contact with any areas of the terminal connections or voltage control parts.

The electrical supply must be switched off at the outset, preferably using a switch in the distribution box, before any installation, maintenance, or repair work is undertaken.
Exterior light must not be installed during rain.

Take account of the minimal separation distance from other objects and the room required around the fitting.
If in any doubt, consult a professional, taking local installation require-ments into account. Some countries stipulate that lighting may be installed only by registered installers.

Clamping screws in electrical connections must be adequately tightened. This is particularly the case with 12Vlow-voltage conductors.
When replacing a halogen lamp, wait for it to cool, for a minimum of 5 minutes.

Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components.
Take account of all available technical information.

Take note of the symbols when connecting wires:
- N = Neutral
- L = Live
- = Earth

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similarly qualified person in order to avoid a hazard.

Protection class 2: the fitting is double insulated and does not require earthing.
Protection class 3: the fitting is low voltage.
Observe the indicated minimum distance between the lamp and the illuminated materials/objects.
Only the self-screening halogen illuminants should be used with the luminaire.
Strip the wire to the indicated length.
Connect using the specified cable.
The fixture can be used in combination with a dimmer. Consult the sales outlet for the correct type of dimmer (important in the case of 12V fittings)
The maximum wattage indicated in each lighting unit, for example, must not be exceeded.
This luminaire cannot be disposed oof togetherwith normal domestic waste, you have to bring it to a staging area for electrical waste.
This luminaire was designed to work only with the indicated voltage.
This shows that the products meet EU safety, health, o environmental requirements.