SensorSwitch™ Mobile App
Visible Light Programming
Quick Start Guide
The SensorSwitch™ Mobile App uses your smartphone’s camera flash or Bluetooth® wireless technology to configure settings on VLP-enabled SensorSwitch occupancy sensors, photo controls, and luminaire-embedded sensors.
Set occupancy time delay, trim values, photocontrol options, and more with this visually intuitive tool. Sensor customization has never been easier.
Download the App
SensorSwitch™ VLP Mobile App
Program Settings
 |
||
| Step 1 Select Sensor. |
Step 2 Set or change the 3-digit PIN within 45 minutes of restored power, or after a deliberate power cycle. |
Step 3 Toggle the high trim option and slide the status bars down to 40%. Select the Next button. |
NOTE: Do NOT stare directly at the flash while transmitting to the sensor.
Step 4
Aim the camera’s flash towards the sensor. Press the Send button. A series of flashes will transmit information to the sensor. Keep the phone pointed at the sensor until you see the “Completed” message. The lights will toggle on and off to confirm successful transmission.
Remember to switch off all applicable breakers before installing the sensor.
Feedback Codes
| Room Lights | LED | Meaning | ||
 |
 |
Blink–Blink |  |
Successfully set PIN and/or configuration option. |
 |
|
Rapid Blink |  |
Correct PIN, configuration not modified. |
 |
|
Rapid Blink |  |
Incorrect PIN, VLP enabled |
|
 |
No Blink |  |
Not VLP enabled |
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by Acuity Brands is under license. Other trademarks and trade names are those of their respective owners.
One Lithonia Way, Conyers, GA 30012 | Phone: 700.922.9000
www.acuitybrands.com
© 2021 Acuity Brands Lighting, Inc. All Rights Reserved.
SSI_925693.03_1021
Documents / Resources
 |
sensorswitch Mobile VLP App [pdf] User Guide Mobile VLP App, Mobile VLP, App |
 |
sensorswitch Mobile VLP App [pdf] User Guide Mobile VLP App, Mobile VLP, App |
