SEEING U-logo

SEEING W2 Window Cleaning Robot

SEEING-U-W2-Window-Cleaning-Robot-fig-1

Remote Control

SEEING-U-W2-Window-Cleaning-Robot-fig-2

Start/Stop Cleaning

SEEING-U-W2-Window-Cleaning-Robot-fig-5

  • After the robot adsorbs successfully, short press “On/OFF” button on the robot or press SEEING-U-W2-Window-Cleaning-Robot-fig-3 on the remote control to start automatic cleaning.\
  • The robot default cleaning mode is Z path.
  • Press SEEING-U-W2-Window-Cleaning-Robot-fig-3 to start /stop cleaning
  • SEEING-U-W2-Window-Cleaning-Robot-fig-6 for vertical glass. Clean with “N” path

    SEEING-U-W2-Window-Cleaning-Robot-fig-8

  • In the status of “Stop”, press SEEING-U-W2-Window-Cleaning-Robot-fig-4 button to control the cleaning direction of the robot, and to switch cleaning path.
  • SEEING-U-W2-Window-Cleaning-Robot-fig-7 for horizontal glass Clean with “Z” path

    SEEING-U-W2-Window-Cleaning-Robot-fig-9

FCC NOTE

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help
  • Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference
  2. this device must accept any interference received, including interference that may cause unde- sired operation.

Documents / Resources

SEEING U W2 Window Cleaning Robot [pdf] User Manual
W2, W2 Window Cleaning Robot, Window Cleaning Robot, Cleaning Robot, Robot
SEEING U W2 Window Cleaning Robot [pdf] User Manual
2BH5X-W2, 2BH5XW2, W2 Window Cleaning Robot, W2, Window Cleaning Robot, Cleaning Robot, Robot

References

Leave a comment

Your email address will not be published. Required fields are marked *