seeed studio SenseCAP Solar Node Instruction Manual

Instruction Manual for SenseCAP Solar Node
Version 2.0

Part List

Hardware Installation

1. Check & Power On
   The device is designed with a battery protection circuit.
   So, when installing the battery for the first time or reinstalling it after removal, charge it via the Type-C port to activate the battery protection circuit. A brief charging signal suffices for activation.
2. Install: Pole Mounting
   Step1: Install on the back of the Solar Node, together with two 10 and two 11.
   Step2: Take out 6 and 8, and connect them with four 12 and four 13. Then thread ⑤ through the corresponding small holes on 6 and connect it to 4

Step3: Use to fix the bracket to a pole with a diameter of 70-100 cm.

Step4: Connect the Solar Node in 【Step1】 with one 10 and one 14.
Step5: Screw the rod-shaped antenna clockwise into the SMA interface of the main unit and tighten it until there is no looseness.

Safety Warnings

1. Operate within the specified temperature range; avoid extreme temperatures.
2. Do not install during thunderstorms, strong winds, or sandstorms. Prioritize personal safety.
3. Do not disassemble or modify the circuit; this may damage waterproofing or the device.
4.  Keep the solar panel free of obstructions to ensure charging efficiency.

Battery Safety

1. Observe correct battery polarity (+/-) during installation.
2. Use only within specified operating conditions.
3. Do not puncture, incinerate, or submerge the built-in lithium battery.
4. Maintain battery charge above 50% during long-term storage.

Precautions

• No Overloading: Don’t exceed the max load current to prevent device damage or safety hazards.
• Keep solar panel clean for best charging.
• Seal for Waterproofing: Despite its protection level, ensure the device is well – sealed to avoid internal short circuits.
• Regular Checks: Routinely inspect for loose connections, battery leakage, and panel damage; address issues immediately.
• Keep Kids Away: Keep children from this device with electrical parts to avoid electric shock risks.

Troubleshooting

After-sales Service

• Warranty: 1-year coverage.
• Contact Us: If you encounter any problems, please feel free to contact us through the following methods:
• For more Product Info and
• Recommended Applications, scan the QR code for the Wiki tutorial

Discord:

https://discord.gg/KtsZRsqZya

Wiki

https://wiki.seeedstudio.com/solar_node/

Email: support@sensecapmx.com