SDC Push Second Adjustable Time Delay
Product Usage Instructions
Installation
- Connect the power supply to the designated terminals according to the fail-safe or fail-secure wiring diagram provided.
- Mount the device securely in the desired location following the installation guidelines.
Adjustable Time Delay
- The lock releases for 1-60 seconds when the button is pressed.
- Pressing the button again during the release period will retrigger a new release period.
- Follow the typical fail-safe or fail-secure wiring diagrams provided based on your security requirements.
- Ensure proper connection of the timer, power, and relay contacts as indicated.
Maintenance
- Regularly check for any loose connections or signs of wear and tear.
- Clean the device as needed to maintain optimal performance.
413N & 423 PUSH SWITCH 1-60 SECOND ADJUSTABLE TIME DELAY
- When the button is pressed, the lock releases for 1-60 seconds.
- If pressed again during the lock release period, the unit will “Retrigger,” starting a new release period.
TYPICAL FAIL-SAFE WIRING
Performance Rating
UL 294 Performance Rating
- Level I: Line Security
- Destructive Attack
- Standby Power
- Level IV: Endurance
All peripheral modules for UL compliance are required to be UL Listed, UL 294.
To be used with a Class 2 power supply or voltage voltage-compatible UL 294 or UL 603 listed power supply
Compliance with ANSI/NFPA 70 National Electrical Code
Specifications
Electrical Specifications
- Input Voltage: 12/24 VDC @ 90mA
- LED Indicator: 12/24 VDC @ 10/20mA
- Output Relay: DPDT
- Max Load: 30 VDC @ 3Amp (Resistive/Inductive)
- Wire Size: 12~22AWG (Single)
Any suggestions or comments on this instruction or product are welcome. Please contact us through our website or email engineer@sdcsecurity.com
TYPICAL FAIL-SECURE WIRING
UL 294 Performance Rating
- Level I: Line Security
- Destructive Attack
- Standby Power
- Level IV: Endurance
All peripheral modules for UL compliance are required to be UL Listed, UL 294.
To be used with a Class 2 power supply or voltage voltage-compatible UL 294 or UL 603 listed power supply
Compliance with ANSI/NFPA 70 National Electrical Code
Electrical Specifications
- Input Voltage: 12/24 VDC @ 90mA
- LED Indicator: 12/24 VDC @ 10/20mA
- Output Relay: DPDT
- Max Load: 30 VDC @ 3Amp (Resistive/Inductive)
- Wire Size: 12~22AWG (Single)
CONTACT
- SECURITY DOOR CONTROLS
- WWW.SDCSECURITY.COM
[t] 800.413.8783 - 805.494.0622
- E-mail: service@sdcsecurity.com
- 801 Avenida Acaso, Camarillo, CA 93012
- PO Box 3670, Camarillo, CA 93011
FAQ
- Q: How do I adjust the time delay on the device?
- A: Use the potentiometer provided to adjust the time delay from 1 to 60 seconds.
- Q: What power supply should I use with this product?
- A: Use a Class 2 power supply or a voltage-compatible UL 294 or UL 603 listed power supply for optimal performance and compliance.
- Q: Can I use this product with an electric strike?
- A: Yes, this product can be used with an electric strike for enhanced security access control.
Documents / Resources
 |
SDC Push Second Adjustable Time Delay [pdf] Installation Guide 413N, 423, 423A, Push Second Adjustable Time Delay, Second Adjustable Time Delay, Adjustable Time Delay, Time Delay |