

’20-’21 FORD F-250/F-350
6.7L Tuning Instructions

SETUP:
- Ensure vehicle is turned off and parked safely.
- Fully open the hood and ensure it is secured.
- Locate the ECU in the firewall on the passenger’s side of the vehicle (See Green Arrow)

- Be sure to release the locking tab (green arrow below) before moving gray connector arm. Disconnect all 3 of the ECU connectors.
Note: You MUST disconnect ALL 3 connectors anytime you are installing or uninstalling your tune.
- Connect the ECU connector provided with the X4 to connection 1 on the ECU as shown above and to the SCT box.

- Connect the X4 to the SCT box using the OBDII cable.

- Connect the SCT box to the battery using the battery clamps provided. Battery Clamps Install: Red to positive, black to negative.

TUNING YOUR ECU:
- Be sure you have completed the setup steps on Page 1 & 2.
- On the X4 select PROGRAM VEHICLE.

- Review and accept the STREET USE NOTICE.

- Select which Custom Tune file you want to program.
- If this is your first flash, you will see SAVING STOCK DATA. This is normal.

- The X4 will now program in the custom tune file. When complete, reconnect the ECU by disconnecting the battery clamps and reconnecting all 3 ECU connections.
TUNING YOUR TCU: - Your ECU is now tuned, plug the X4 OBDII cable into your OBDII port under your dash to begin programming your TCU.
- On the X4 select PROGRAM VEHICLE.

- Review and accept the STREET USE NOTICE.

- Follow the on-screen key prompts.
- If this is your first flash, you will see SAVING STOCK DATA.
This is normal.

- After stock has been saved the device will begin the tuning process.

- When complete, turn the key off and select DONE to return to the main menu. Tuning is now complete, you can disconnect the X4.
RETURN YOUR ECU TO STOCK:
- Be sure you have completed the setup steps on Page 1 & 2
- On the X4 select PROGRAM VEHICLE.

- Review and accept the STREET USE NOTICE and press RETURN TO STOCK.
- Confirm Return to Stock.

- The X4 will now program in the stock file.

- When complete, reconnect the ECU.

RETURN YOUR TCU TO STOCK:
- PLUG INTO OBDII
- On the X4 select PROGRAM VEHICLE.

- Review and accept the STREET USE NOTICE and press RETURN TO STOCK.
- Confirm Return to Stock.

- The X4 will now program in the stock file.

- Your vehicle is now back to stock.

LIVELINK GEN-II / ADVANATAGE III
To use Live Link with the 2020-2021 F-250/F350 6.7L please update to the current release version including any outstanding database updates.
LIVELINK GEN-II: Version 2.9.4.0 or newer, including any outstanding database updates.
ADVANTAGE 3: Version 3.4 Build 22305.0 or newer.

For technical assistance please go to
www.scflash.com and click support.
Documents / Resources
![]() | X4 Power Flash Programmer |
References
- Gas & Diesel Tuners | Tuning Software | SCT Flashwww.sctflash.com
- User Manualmanual.tools
Published: October 15, 2023
