CONTILED
Installation instructions
INSTALLATION INSTRUCTIONS
CONTILED LED Lighting in a Continuous Line for Safer Tunnels
| CONTILED 1 | CONTILED 2 | |
| L | 618 mm | 1218 mm |
| W | 133 mm | 133 mm |
| H | 71 mm | 71 mm |
| kg | 4.15 kg | 7.15 kg |
SYSTEM CABELING
INTERNAL SHUNT
END OF CHAIN
| CONTILED 1 | ONTILED 2 | |
| L | 583 mm | 1183 mm |
EXTERNAL SHUNT
5 POLE double circuit
3 POLE single circuit
5 POLE double circuit
SAFETY INSTRUCTIONS
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. Always switch off the power prior to installation, maintenance or repair activities.
ENG RISK GROUP 2 –
CAUTION! Hazardous optical radiation may be emitted from this product. Do not stare at the luminaire when operating as it may be harmful to the eyes. The luminaire should be positioned so that prolonged staring at the luminaire at a distance of less than 0.47m is not expected.
This product contains a light source of an energy efficiency class G or higher.
In case of PVC insulated mains cable, the installer MUST ensure that the WHOLE cable is protected against climatic conditions, especially UV rays and rain, by making sure that the cable is contained inside the luminaire and pole
Y-connection: In case of damage to the wire, it has to be replaced only by the manufacturer, distributor or by an expert, to avoid risks.
00-24-392
DOC-0012626 rev H
01-2022
www.schreder.com
Documents / Resources
 |
Schreder CONTILED LED Lighting in a Continuous Line for Safer Tunnels [pdf] Instruction Manual 167.5, 15x6.5, CONTILED LED Lighting in a Continuous Line for Safer Tunnels, CONTILED, LED Lighting in a Continuous Line for Safer Tunnels |