Installation and operating instruction
Self-contained Autotest emergency luminaire NLK5U413SC
Technical data
| Viewing distance: | 20m |
| Illuminant: | LED |
| Mains voltage: | 220-240V 50/60Hz |
| Autonomy time: | 3h |
| Battery | LiFePO4 3.2V 1500mAh |
| Connected load: | 3.5W |
| Protection category: | IP 65 |
| Insulation class: | II |
| Permitted temp. range: | 0° C to +55° C |
| Mounting: | Wall, ceiling (optionally ceiling recessed) |
Self-contained Autotest emergency luminaire according to EN 60598-1, EN 60598-2-22, ISO 7010 and EN 1838 for wall- or ceiling mounting. Suitable for maintained and non-maintained operation. Pictogram set (left, right, up and down) included.
Security advice:
Attention: Works on the 230V AC mains may only be done from qualified personnel considering the local installation requirements. Before installation the supply voltage must be switched off.
Remark: In order to attain the full functionality of a self-contained emergency luminaire the battery has to be charged for min. 24 hours.
Caution: Claims for warranty cannot be lodged in the event of damage caused by non-observance of this instruction. No liability for follow-on damages resulting from this can be accepted. The installation instruction must be read thoroughly before commissioning the product.
Dimensional sketch:
Important: Make sure the battery is replaced as stated in regulations otherwise the function of the lamp is not guaranteed.
When replacing the battery ! Do not use abrasive cleaners or cleaners that contain solvent.
Mounting instruction Design K5
Schrack Technik GmbH
Seybelgasse 13, A – 1230 Vienna, PHONE +43 1/866 85-0
E-MAIL info@schrack.com, INTERNET www.schrack.com
PAGE 2/2
06-2023
Errors and omissions excepted.
Documents / Resources
 |
SCHRACK TECHNIK NLK5U413SC Self Contained Autotest Emergency Luminaire [pdf] Instruction Manual NLK5U413SC Self Contained Autotest Emergency Luminaire, NLK5U413SC, Self Contained Autotest Emergency Luminaire, Autotest Emergency Luminaire, Emergency Luminaire, Luminaire |