SCANSTRUT PTM-R1-SL Tapered Mast For Radar And Starlink
Product Specifications
- Product Name: Tapered Mast for Radar and Starlink PTM-R1-SL and PTM-R2-SL
- Model Numbers: PTM-1-S40, PTM-2-S40
- Issue Number: 15-03-24 (Issue 1)
- Manufacturer: Scanstrut
Part List
60005574
FLIR M100/200 riser kit
Parts Required
Tools Required
Riser kit only 
INSTALLATION
Waterproof Cable Routing
- Use the ø8.5mm bung supplied for routing the Starlink cable.
- For routing a number of cables.
Recommended Starlink Cable Length
Pass a smaller connector through the cable seal until the length is at least 600m (23.6”).
FLIR M100/200 riser kit assembly
IMPORTANT
- No liability is accepted for damage caused by incorrect installation.
- The installation and assembly must be regularly inspected for evidence of damage or loose parts.
- The product has been designed specifically for the mounting of approved marine electronics under normal boating conditions.
UK & International
+44 (0)1392531280
sales@scanstrut.com
For further installation and warranty information please visit: www.scanstrut.com
USA
+1 860 308 1416 usasales@scanstrut.com
Frequently Asked Questions
- Q: What tools are required for installation?
- A: You will need a flat head and Pozi screwdriver, hole saw, allen keys, and spanners as specified in the manual.
- Q: What is the recommended cable length for Starlink?
- A: Pass the smaller connector through the cable seal until the length is at least 600mm (23.6 inches).
- Q: Is the product suitable for marine electronics?
- A: Yes, the product has been designed specifically for mounting approved marine electronics under normal boating conditions.
Documents / Resources
 |
SCANSTRUT PTM-R1-SL Tapered Mast For Radar And Starlink [pdf] Installation Guide PTM-R1-SL Tapered Mast For Radar And Starlink, PTM-R1-SL, Tapered Mast For Radar And Starlink, Mast For Radar And Starlink, Radar And Starlink, And Starlink, Starlink |