Multipurpose and Rechargeable LED Work Light
User Guide
MAG PRO
03.5690
3 Years warranty*
PATENT PROTECTED
* go to scangrip.com to register
WARNING / CHARGING INSTRUCTION / BATTERY TIPS
- Avoid looking directly into the beam of light, as this will result in dazzling
- Do not use the lamp near a naked flame
- Before using the lamp for the first time, the battery must be fully charged
- Recharge frequently
- Always replace the battery with an original SCANGRIP battery
- Do not leave the battery without charge for an extended period
– Deep discharge risks damaging the battery - The light source of this lamp is not replaceable; when the light source reaches its end of life the whole lamp shall be replaced
- Only charge the lamp indoors at min 0 °C
USE
- The lamp has an indicator for charging and battery capacity. 4 LEDs for indicating 25%, 50%, 75% and 100%
- During charging the LEDs light red. All LEDs will turn green when fully charged
- For battery capacity, press and hold the power button while the lamp is off. When battery capacity is below 25%, the bottom left LED is flashing green
- Switch sequence: MAIN, SPOT, OFF
- If the power button is not pressed within 3 seconds, the next press will turn off the lamp
- Press and hold the power button while the main light is on to start dimming. Release, press, and hold again to increase
- Lowest and highest levels are indicated by flashing of the light until the button is released
- When the lamp is turned off the lamp will remember the setting of the main light
Discarded electrical products must not be disposed of together with household waste. Please use recycling facilities. Ask your local authority or retailer for advice on recycling.
- The battery must be removed from the device before it is broken up
- The device must be disconnected from the mains when the battery is removed
- Please dispose of the battery safely
MANUFACTURER’S WARRANTY – Information for customers in Australia and New Zealand only
This SCANGRIP product is guaranteed for a period of 2 (two) years from the date of purchase. This guarantee shall become invalid if the product has been misused, tampered with, or accidentally damaged.
If the product is defective, we undertake to repair or replace the product or any part of it that is defective; or wholly or partly recompense you if they are defective.
This guarantee is in addition to other rights and remedies available to consumers, all of which are given by us to you if you are a consumer. Our goods come with guarantees that cannot be excluded under the Australian or New Zealand Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
If you wish to make claim, please return this product to the original place of purchase together with your purchase receipt or go to our website www.scangrip.com and fill out the claim form.
http://QRly.me/packaging-manuals/qr/03-5108-magpen-2-manual-1
DESIGNED BY SCANGRIP IN DENMARK
EU DESIGN PATENT NO. 2954123
CN DESIGN PATENT NO. ZL201630333466.3
CN UTILITY PATENT NO. ZL201620770387.3
V1/11.2021/CXQ
// SCANGRIP A/S Rytterhaven 9 DK-5700 DENMARK
Documents / Resources
 |
SCANGRIP 03.5690 Multipurpose and Rechargeable LED Work Light [pdf] User Guide 03.5690, Multipurpose and Rechargeable LED Work Light, 03.5690 Multipurpose and Rechargeable LED Work Light, Rechargeable LED Work Light, LED Work Light, Light |
