satel INT-KLCD-GR LCD Keypad for Integra Control Panels
Important Information
The device should be installed by qualified personnel.
Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty.
Disconnect power before making any electrical connections.
Tips for Installation
- The keypad should be installed indoors, in spaces with normal air humidity.
- The place of installation should be readily accessible to the system users.
- To connect the keypad, use an unshielded non-twisted cable.
Installation
- Open the keypad enclosure.
- Place the enclosure base on the wall and mark the location of mounting holes.
- Drill the holes in the wall for wall plugs (anchors).
- Run wires through the opening in the enclosure base.
- Using wall plugs (anchors) and screws, secure the enclosure base to the wall. Select wall plugs specifically intended for the mounting surface (different for concrete or brick wall, different for plaster wall, etc.).
- Screw the wires to the keypad terminals. For instructions on how to connect the wires, please refer to the control panel installer manual.
- Close the keypad enclosure
Customer Support
SATEL sp. z o.o.
ul. Budowlanych 66; 80-298 Gdansk, POLAND
tel. +48 58 320 94 00; www.satel.p
Prior to keypad installation, please read carefully the control panel installer manual. It is available at www.satel.pl. Scan the QR code to go to our website and download the manual.
Documents / Resources
 |
satel INT-KLCD-GR LCD Keypad for Integra Control Panels [pdf] Installation Guide INT-KLCD-GR LCD Keypad for Integra Control Panels, INT-KLCD-GR, LCD Keypad for Integra Control Panels, Integra Control Panels, Control Panels |
