SALUS SW600 Window and Door Sensor
PRODUCER:
Salus Limited
6/F, Building 20E, Phase 3, Hong Kong Science
Park, 20 Science Park East Avenue, Shatin,
New Territories, Hong Kong
www.salus-controls.eu www.sysclima.com
SALUS Controls es miembro del Grupo Computime.
Introduction
A window/door sensor is a small, wireless piece of equipment that detects when a window/door is open or closed. The Slim Window/Door Sensor is used primarily on windows and doors where the installtion location is narrow. This product must be used with the Universal Gateway (UG600/UGE600) and the Salus Smart Home App .
Product Compliance
This product complies with the essential requirements and other relevant provisions of Directives 2014/53/EU (RED) and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.saluslegal.com
Safety Information
Use in accordance with the regulations. Indoor use only. Keep your equipment completely dry. Disconnect your equipment before cleaning it with a dry towel.
Positioning
Power up & Pairing
Follow the onscreen instructions up to
Install the slim window/door senor using the screws or the double-sided tape.
Opened/Closed
Factory reset
Keep the reset button pressed for 4 seconds when inserting back the battery. The device will reset and enter pairing mode.
Documents / Resources
 |
SALUS SW600 Window and Door Sensor [pdf] User Guide SW600, Window and Door Sensor |
 |
SALUS SW600 Window and Door Sensor [pdf] User Guide SW600, Window and Door Sensor, SW600 Window and Door Sensor, Door Sensor, Sensor |
 |
SALUS SW600 Window and Door Sensor [pdf] User Guide SW600, Window and Door Sensor |
 |
SALUS SW600 Window and Door Sensor [pdf] User Guide SW600 Window and Door Sensor, SW600, Window and Door Sensor |
