SAGA1-L Series Wireless Remote Controls
“
Product Information
Specifications:
- Product Name: SAGA 1 Wireless Remote Controls
- Series: SAGA1-L
- Models: SAGA1-L4, SAGA1-L6, SAGA1-L6B, SAGA1-L8, SAGA1-L8B
- Compliance: FCC Part 15
- Radiation Exposure Limits: FCC compliant for uncontrolled
environment
Product Usage Instructions
Safety Precautions:
1. Do not make any changes or modifications to the device not
approved by the manufacturer.
2. Keep a minimum distance of 0cm between the device and your
body during operation.
Operating Instructions:
- Ensure the device is powered on and within range for wireless
operation. - Press the appropriate buttons on the remote control to send
signals to the paired receiver. - Follow any specific instructions provided for the equipment
being controlled. - After use, store the remote control in a safe and dry
place.
Maintenance:
1. Clean the remote control with a dry cloth to remove any dust
or dirt.
2. Replace the batteries when the remote control shows signs of
low power.
FAQ (Frequently Asked Questions)
Q: How do I pair the remote control with a receiver?
A: The pairing process may vary based on the receiver model.
Refer to the receiver’s manual for specific pairing
instructions.
Q: What should I do if the remote control stops working?
A: Check the battery levels and replace them if necessary.
Ensure there are no obstructions between the remote and the
receiver.
“`
”
SAGA 1
`a
SAGA 1
ers Gui
For
SAGA1-L Series -SAGA1-L4 -SAGA1-L6 -SAGA1-L6B -SAGA1-L8 -SAGA1-L8B
Wireless Remote Controls
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Documents / Resources
 |
Sagatronic SAGA1-L Series Wireless Remote Controls [pdf] User Guide SAGA1-L Series Wireless Remote Controls, SAGA1-L Series, Wireless Remote Controls, Remote Controls, Controls |