Application User Manual

Scan & Download

https://cms.wifigsmalarm.com/listing/download.html

Connection steps:

1. Find tag 1 battery and connect it to the sock, make sure the battery into the power state, open the app, it will be automatically connected.
2. Left slide control bar click to enter the edit page.
3. Customize the name for this battery.
4. Connect the Tag 2 battery in the same way.

1. Equipment Name
2. Current temperature
3. Heating time
4. Current level
5. Switchgear
6. Go to Settings
   (Click to go to the settings page)

Note: If you purchase two pairs of socks and connect them, four control bars will appear, click on any one of them to control all the socks at the same time. When you close any of the control bars, it will disconnect that sock.

When sock 1 and sock 2 are blue at the same time, it means that sock 1 and sock 2 are selected for dual control of the device.

When sock 1 is blue and sock 2 is transparent, it means that sock 2 is disconnected and stays in the state before disconnection, at this time the App only controls sock 1.

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance Ocm between the radiator and your body.

Documents / Resources

SAFEIER Application [pdf] User Manual PBDY302, 2BRSS-PBDY302, 2BRSSPBDY302, Application

References

• User Manual