EOS WITH DEPLOYER
INSTRUCTIONS
FOR THERMAL POOL COVERS

EOS with Deployer for Thermal Pool Covers

USING THE EOS WITH DEPLOYER TO PLACE COVERS ON THE POOL

1. Unlock brakes on reels and move into desired position on the pool deck.
2. Lock the brakes to prevent unwanted movement.
3. Unplug EOS from the wall charger and roll to the storage reel.
4. Grab the deployer and roll the spool to directly line up across the pool from the center of the reel
5. Grab the line from the deployer and unspool and walk across the side of the pool and then connect/attach to the cover.
6. Locate the channels on the bottom of the Deployer and roll the EOS into/on top of those channels and then align the square bolt from the deployer and female receiver from the EOS. Note you may need to adjust the EOS vertically to align correctly with the deployer.
7. Once ready, press the ____ button and retrieve the line and pull the cover across the pool.
   Note: keep a staff member at the storage reel to control any excess speed while the tube unfurls.
8. Repeat alignment bullets from above

800.824.4387 
srsmith.com/thermalpoolcovers

Documents / Resources

S R Smith EOS with Deployer for Thermal Pool Covers [pdf] Instructions DP100, EOS with Deployer for Thermal Pool Covers, EOS with Deployer, Thermal Pool Covers, EOS

References

• User Manual