IKEA Bedside Table Instruction Manual

IKEA Bedside Table

Надview

This manual section covers the listed hardware/parts and provides step-by-step instructions for assembling the cabinet base frame and assembling the cabinet and drawer.

Hardware & Parts Reference

Инструкция по сборке

1. Base & frame assembly: Assemble rails 14 and 15 using bracket K (repeat for two corners).
2. Add rail 13 to the assembly of rails 14 and 15; tighten using screw C with wrench L.
3. Complete the base frame by adding rail 12 to rails 13, 14, and 15; secure bracket K with screw C and wrench L.
4. Attach the assembled base frame to the bottom of the cabinet body (part 2) using screws D.
5. Cabinet & drawer assembly: Attach side panels 8 and 9 to base panel 7 using screws A.
6. Slide back panel 11 into the grooves of side panels 8 and 9.
7. Secure top panel 10 to the side panels 8 and 9 using four screws G.
8. Attach drawer handle I to the drawer front using screw J.
9. Attach drawer slides (E2) to the sides of the drawer using screws H.
10. Insert the completed drawer into the main cabinet unit.
11. Assembling rails 14 and 15 using bracket K. The ‘x2’ indicates this is done for two corners. Inset showing the placement of bracket K onto the rail corner.
12. Adding rail 13 to the assembly of rails 14 and 15. An 80% completion circle is shown. Inset showing screw C being tightened with wrench L to secure the rail.
13. Completing the base frame by adding rail 12 to rails 13, 14, and 15. An 80% completion circle is shown. Inset showing bracket K being secured with screw C and wrench L.
14. Attaching the assembled base frame to the bottom of the cabinet body (part 2) using screws D.
15. The base frame is shown fully attached to the cabinet body. A 100% completion circle is shown. Inset showing wrench L being used for final tightening of the assembly.
16. Финал view of the assembled cabinet. Inset showing hardware M and N being used to attach a component to the drawer front (part 6).
17. Side panels 8 and 9 are attached to base panel 7 using screws A. Inset diagrams show screw alignment.
18. Drawer slides E2 are attached to the sides of the drawer (8 and 9) using screws H. An inset shows the slide detail.
19. The completed drawer is inserted into the main cabinet unit.