AKK specializes in high-performance FPV (First Person View) drone electronics, including long-range video transmitters, cameras, and antennas for RC hobbyists.
AKK is a well-known manufacturer in the RC FPV (First Person View) community, dedicated to producing innovative electronic components for drone racing and long-range freestyle flying. The brand's product portfolio is centered around robust Video Transmitters (VTX) that feature switchable high-power outputs, Smart Audio support, and wide voltage inputs to accommodate various drone builds.
In addition to video transmission systems, AKK offers FPV cameras, versatile antennas, and accessories like pigtail connectors. Their products are designed to integrate seamlessly with standard flight controllers and OSDs (On-Screen Displays) such as Betaflight, allowing pilots to adjust settings like frequency bands and power levels directly from their radio transmitters. AKK components are recognized for delivering reliable signal strength and durability for both amateur and professional drone pilots.
Последние руководства от manuals+ специально для этого бренда.
Распространенные вопросы о руководствах, регистрации и поддержке этого бренда.
On many AKK VTX models, you can press the function button for about 6 seconds until the LED flashes a number, then short press to cycle through power levels (e.g., 200mW, 400mW, 1000mW). Always verify the specific sequence in your model's manual.
Pit Mode reduces the VTX output power to a very low level to prevent interference with other pilots while you are configuring your drone or upgrading firmware in the pits. You can typically exit this mode via Betaflight OSD or by holding the button for a set duration.
Yes, many AKK VTX units support Smart Audio, allowing you to change channels, bands, and power output directly through your drone's OSD (Betaflight) without pressing physical buttons.
Video transmitters generate significant heat, especially at high power outputs. It is recommended to mount the VTX on the uppermost layer of the drone frame where it can receive adequate airflow for heat dissipation.
The LEDs typically indicate the current Band, Channel, and Power level. For example, a flashing number often corresponds to a specific power setting (e.g., 1 flash for 25mW, 2 flashes for 200mW). Refer to the specific user manual for the LED code table.