ROSA Cuddle Ii LED Reg Owner's Manual
TECHNICAL DATA
1) tolerance +/- 5% due to LEDs accuracy
2) symbol of chosen optical system eg. 2223133/6/T2 is CUDDLE II LED REG 48 5000K with T2 optical system
2) symbol of chosen optical system eg. 2223133/6/T2 is CUDDLE II LED REG 48 5000K with T2 optical system
DIRECTIVES AND STANDARDS
DIRECTIVES: 2014/35/UE (Official Journal of the UE L 96/357 29.03.2014), 2014/30/UE (Official Journal of the UE L 96/79 29.03.2014), 2011/65/UE, 2009/125/EC STANDARDS: –
CHARGING DISCHARGE FROM THE LED LUMINAIRE HOUSING
In order to efficient discharge the electrostatic charge from the housing of LED setting installed on the pole from dielectric material (non-conductive) one of the following solutions is required:
– functional grounding
– LED luminaire with an additional protection device
– functional grounding
– LED luminaire with an additional protection device
TECHNICAL DRAWING
PHOTOMETRIC CURVES
POWER SYSTEM FUNCTIONS
Luminaire in standard has following functions of intelligent power supply:
- Connection to outside control system by DALI interface (operation of analog signal 1-10V as an option),
- Possibility of programming multistage dimming of luminaire, up to 5 intervals in the range of from 10 to 100% of nominal power,
- Temperature protection of LED module (from overheating) in case of unintentional luminaire operation during the,
- Regulation of power / luminous flux – the option of setting another value than the catalogue in the range of 30-100% of nominal one,
ACCETABLE QUANTITY OF LUMINAIRES ON ONE CIRCUIT
Zakład Produkcji Sprzętu Oświetleniowego „ROSA” Sp. z o.o.
43-109 Tychy, ul. Strefowa 1 tel. +48 32 73 88 901
www.rosa.pl
43-109 Tychy, ul. Strefowa 1 tel. +48 32 73 88 901
www.rosa.pl
Updated at: 29-06-2023
Contents
hide
Documents / Resources
 |
ROSA Cuddle Ii LED Reg [pdf] Owner's Manual Cuddle Ii LED Reg, LED Reg, Reg |