RASCGORMLVER.1 Cable Guide Open Roll
“
Product Specifications:
- Model: RAS – Rollashade Cable Guide Open Roll Manual
- Manufacturer: Rollashade
- Address: 12101 Madera Way Riverside, CA 92503
- Phone: 888-245-5077
- Fax: 951-245-5075
- Website: www.rollashade.com
Product Usage Instructions:
1. Left, Right Open Bracket Installation:
Drill holes for wall, ceiling, or side installation. Consider
using a center fascia bracket for additional support for larger
spans.
2. Wire Preparation:
Mark and secure wire guide fixings. Trim wire to your
measurements, leaving excess for adjustments.
3. Spring Installation:
Insert spring into wire and hook terminal. Ensure proper
alignment and levelness.
4. Gear Installation:
Install gear with provided pins according to instructions.
5. Shade Installation:
Insert spring into wire and hook terminal, paying attention to
the control end placement.
6. Wire Insert:
Thread wire through weight bar end cap floats and tighten screws
securely.
7. R-Clip Installation:
Securely insert R-Clip onto idler adapter and tighten screws to
maintain tension.
8. Tension Guideline Installation:
Slide adjusting sleeve and wire terminal onto wire, then tighten
with Allen key for proper tension.
9. Installation Complete:
Follow the visual guide provided to ensure the installation is
complete.
Frequently Asked Questions (FAQ):
Q: Do I need any additional tools not listed in the
manual?
A: The tools listed in the manual should be sufficient for the
installation process. If you encounter any issues, please contact
customer support.
Q: How do I adjust the tension of the wires?
A: Use the provided Allen key to tighten or loosen the wires as
needed to achieve the desired tension level.
“`
12101 Madera Way Riverside, CA 92503 Phone: 888-245-5077
Fax: 951-245-5075 www.rollashade.com
RAS – Installation Instructions Cable Guide Open Roll Manual
Hardware Included
Tools Required
Flat Head
Phillips Head
Allen Key Set
Left and Right Open Brackets
Pliers
Heavy Duty Wire Cutters
Saw
Shade + Weight Bar
1 1/2″ Self Tapping Phillips Screws
R-Clip
Gear Arm Wire Tension Bottom Wire Guide Swaged Dome Ter-
Springs x2 Swivel Bracket x2
minal +
4.2mm Wire Rope x2
Drill Measuring tape
Mallet Scissors
Pencil
www.rollashade.com
© Copyright 2025 Roll A Shade® Inc., All rights reserved. – Contractor #916075
RASCGORMLVER.1 Page 1 of 5
1. Left, Right Open Bracket Installation
Drill holes for wall, ceiling or side installation Note: Center fascia bracket may be required for center support for larger spans if needed.
2. Wire Preparation
Mark and secure wire guide fixings. Trim wire to your measurements. Note: Make sure to give yourself excess wire to cut later for a smoother installation process.
WALL MOUNT
FLOOR FIX
CEILING MOUNT
FACE/SIDE FIX
SIDE MOUNT
FLOOR FIX (Optional for securing to masonry)
3. Spring Installation
Insert spring into wire and hook terminal. Note: Use dotted lines to assist in your installation process & make sure box is aligned and level.
A
B
C
D
www.rollashade.com
© Copyright 2025 Roll A Shade® Inc., All rights reserved. – Contractor #916075
RASCGORMLVER.1 Page 2 of 5
4. Gear Installation Install gear with pins provided
A
B
8. Tension Guideline Installation
Slide adjusting sleeve then wire terminal onto wire and tighten with Allen key.
5. Shade Installation
Insert spring into wire and hook terminal. Note: Insert control end first.
2mm Allen key
FLOOR FIX
A
Align terminal flange with M4 to grub
srew to clamp
FACE/SIDE FIX
6. Wire Insert Insert wire through wight bar end cap floats.
B
x3
Tighten x3 grub srews per wire
C
Lower adjusting sleeve into collar &
tension wire
7. R-Clip Installation
Insert R-Clip onto idler adapter. Make sure it is clipped in securely.
D
Screw in adjusting sleeve until
wire tightens.
E
x5
Tighten x5 turns using Allen key.
www.rollashade.com
F
Screw in grub screw to prevent
losing tension
© Copyright 2025 Roll A Shade® Inc., All rights reserved. – Contractor #916075
RASCGORMLVER.1 Page 3 of 5
9. Installation Complete Below is a visual of the complete product once installed.
www.rollashade.com
© Copyright 2025 Roll A Shade® Inc., All rights reserved. – Contractor #916075
RASCGORMLVER.1 Page 4 of 5
www.rollashade.com
© Copyright 2025 Roll A Shade® Inc., All rights reserved. – Contractor #916075
RASCGORMLVER.1 Page 5 of 5
Documents / Resources
 |
ROLL A SHADE RASCGORMLVER.1 Cable Guide Open Roll [pdf] Installation Guide RASCGORMLVER.1, RASCGORMLVER.1 Cable Guide Open Roll, RASCGORMLVER.1, Cable Guide Open Roll, Open Roll, Roll |