CONTRACT PLUS+ 4” BOTTOM FASCIA
INSTALLATION INSTRUCTIONS
CONTRACT PLUS+ 4 Inch Bottom Fascla
INSIDE OR OUTSIDE APPLICATION
**NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL**
MOUNTING LOCATION
Place your first bracket in its mounting location and mark the screw holes. Place your second bracket in its mounting location and repeat the process.
SCREW INSTALLATION
Next, pre-drill your screw holes using a 1/8” drill bit. Install the brackets with the provided screws using the 1/4” hex head driver.
ALIGNMENT
Check to make sure your brackets are level and aligned.
SHADE PIN END INSTALLATION
Swivel ball bearing to align with idler shaft for easy installation. Press idler shaft all the way to the bracket.
MOTOR END INSTALLATION
Remove locking ring. Lineup to motor bracket. Push motor into motor bracket.
LOCK RING & FASCIA INSTALLATION
Add locking ring to motor bracket. Check motor is secured correctly. Install bottom fascia.
PLUG IN MOTOR
- Run motor power cord to nearest power outlet.
- Install wire tie pads and secure with zip ties to hold wire down.
- The path of the wire should be parallel with mullions and/or drop ceiling tiles ensuring the cable is neatly organized.
- Any modifications to the power cable should be done by a certified electrician to meet your city/state code requirements.
SHADE ADJUSTING (IF NECESSARY)
- Roll shade up and down to confirm hembar is level and material rolls up straight on center tube.
- If the hembar is not level, lower shade until you see the metal tube.
- Add layers of masking tape to the metal tube to the end that is too low until hembar is straight.
- If the material tracks to one side, lower shade until you see the metal tube.
- Add layers of masking tape to the metal tube to the end that is opposite the direction of tracking, until shade rolls up straight.
ADJUSTING LIMITS (IF NECESSARY)
See programming instructions based on the motor used for your application.
RASCP4BMVER.3 5 OF 5 | © Copyright Roll A Shade® Inc. All Rights Reserved.
Documents / Resources
 |
ROLL A SHADE CONTRACT PLUS+ 4 Inch Bottom Fascla [pdf] Installation Guide CONTRACT PLUS 4 Inch Bottom Fascla, CONTRACT PLUS, 4 Inch Bottom Fascla, Bottom Fascla, Fascla |