RHINO ED DI Expansion Module Owner's Manual

Contents hide

1 RHINO ED DI Expansion Module

2 DEVICE OVERVIEW

3 TECHNICAL PARAMETERS

4 Connection Diagram

5 FCC STATEMENT

6 Documents / Resources

6.1 References

7 Related Posts

RHINO ED DI Expansion Module

Rhino ED Dl
Expansion module to the Rhino AP. Reads data from devices via pulse inputs (SO). Data transfer wireless via RF to the Rhino AP. Powered by an internal high-capacity battery.

DEVICE OVERVIEW

SO pulse connections

SMA ISM antenna connector

TECHNICAL PARAMETERS

Rhino Communication Frequency range: 915 MHz, ISM l channel

Power supply 3.6V AA lithium battery (expected lifetime -7years)
Input 3 X 3,6V pulse input (default- Max 24Vvoltage input) or 3V – ll.BV pulse input (DIP swich enabled – max24Vvoltage input) 2 X binary input (configurable remotely)

Configuration Over the Air (OTA)
Operating temperature range 0 ° C – 85 ° C (depending upon installed environment)

IP Class I P40 (not suitable for outdoor use IP68 box available)
Dimensions 52.5 mm x 90 mm x 65 mm (3 DIN modules)

Weight ~0.l kg
Additional equipment l x ISM antenna with 3m cable and magnetic base

Required cable types Signals thickness – 0.129-l.31 MM2 – 26-l6AWG
Certifications CE , FCC, ISED, RoHS

Connection Diagram

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class a digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver,
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/1V technician for help.

This device complies with part IS of the FCC Rules. Operation is subject to the following two conditions

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification or Declaration of this device and may cause interference levels which exceed the limits established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with this device. This equipment has more than one interface connector do not leave cables connected to unused interfaces- Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

FCC 10:
2BE63EDD1915V14

INNOVATION, SCIENCE AND ECONOMIC DEVELOPMENT CANADA STATEMENT
This device complies with RSS-210 of the Innovation, Science and Economic Development Canada Rules.

Operation is subject to the following two conditions

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

Radiation exposure statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the antenna of this device and all nearby persons, This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter,

IC ID 32201-EDD1915V14