RF Solutions HORNETPRO Remote Con FERRET Engineers Guide
This guide is for advanced setup configuration for additional functionality. This setup should be configured by a professional installer ONLY and not by the end user.
Control and Monitor Output from a Smartphone – RIoT Control
FERRET can be used as part of the RIOT Internet Control and monitoring System.
Ferret can be controlled from a smartphone device via the internet, and the status of its relay output can be sent back to a user’s Smartphone / RIoT Website for real-time monitoring
This requires a RIoT HUB (which provides an RF to Internet Gateway)
Please see the RIoT Control Datasheets for further information.
FERRET Engineers Guide
Simplified Declaration of Conformity (RED)
Hereby, RF Solutions Limited declares that the radio equipment type defined within this document is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.rfsolutions.co.uk
Send a RIOT Learn Signal
Briefly preset a magnet to the FERRET Reed Switch as shown below
Note, most key fobs and handheld transmitters contain a secret magnet within their enclosure
Connecting an External Antenna
The fixed antenna that is supplied with FERRET is a single piece of Wire.
This can be removed, and an external antenna can be fitted to the UFL Antenna Connection
RF Solutions offers several lengths of Coax Cable assembly CBA-UFLSMA, which plugs directly onto the UFL Antenna connector and provides a panel mount SMA connector.
There is a large selection of suitable antennas with varying form factors, all of which have a matching SMA connector.
ANT-GSM5WM
- Wall mount antenna
- 3m cable
- Active gain: +5dB
- RG58 Coax
ANT-PUKDB
- Vandal-Proof Panel Mount
- 1.5m Coax to SMA
- 433 / 868MHz
- Active gain: +2dB
EG-FERRET-5
For any Queries regarding Compliance, please email our European Authorised Representative:
TCFS Europe Ltd. Suite 10258, 77 Sir John Rogerson’s Quay, Dublin 2, D02 F540, Ireland.
Website:www.tcfs-europe.com
Email: rfsolutions@tcfs-europe.com
RF Solutions Ltd. Recycling Notice
Meets the following EC Directives:
DO NOT
Discard with normal waste, please recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/EU
Specifies certain limits for hazardous substances.
WEEE Directive 2012/19/EU
Waste electrical & electronic equipment. This product must be disposed of through a licensed WEEE
collection point. RF Solutions Ltd. fulfils its WEEE obligations by membership of an approved compliance scheme.
Environment agency registration number: WEE/JB0104WV.
Waste Batteries and Accumulators
Directive 2006/66/EC
Where batteries are fitted, before recycling the product, the batteries must be removed and disposed of at a licensed collection point.
RF Solutions battery producer number: BPRN00060.
Disclaimer
Whilst the information in this document is believed to be correct at the time of issue, RF Solutions Ltd does not accept any liability whatsoever for its accuracy, adequacy or completeness. No express or implied
warranty or representation is given relating to the information contained in this document. RF Solutions Ltd reserves the right to make changes and improvements to the product(s) described herein without notice.
Buyers and other users should determine for themselves the suitability of any such information or products for their own particular requirements or specifications (s). RF Solutions Ltd shall not be liable for any loss or damage caused as a result of the user’s own determination of how to deploy or use RF Solutions Ltd’s products. Use of RF Solutions Ltd products or components in life support and/or safety applications is not authorised except with express written approval. No licences are created, implicitly or otherwise, under any of RF Solutions Ltd’s intellectual property rights. Liability for loss or damage resulting or caused by reliance on the information contained herein or from the use of the product (including liability resulting from negligence or where RF Solutions Ltd was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict RF Solutions Ltd’s liability for death or personal injury resulting from its negligence.
RF Solutions Ltd
William Alexander House, William Way, Burgess Hill, West Sussex, RH15 SAG
Support: +4410) 1444 227909
Sales: +44(0) 1444 227900
www.rfsolutions.co.uk
Documents / Resources
 |
RF Solutions HORNETPRO Remote Con FERRET Engineers Guide [pdf] User Guide HORNETPRO Remote Con FERRET Engineers Guide, HORNETPRO, Remote Con FERRET Engineers Guide, FERRET Engineers Guide, Engineers Guide |