NOTE: SHOWN FOR RIGHT WALL MOUNT.
FOR LEFT WALL MOUNT:
REMOVE ACORN NUTS, ROTATE FRONT PLATE 180 AND RE-INSTALL ACORN NUTS.
BRC-14CR_CUST Side Mount Belt Rack
| PART DIMENSIONS | ||
| MIN | MAX | |
| WIDTH | 2. | |
| DEPTH | 14. | 28. |
| HEIGHT | 2. | |
| WEIGHT | ||
| DIAMETER | ||
| RADIUS | ||
| CONTAINTER CAPACITY | ||
| CONTAINER UOM | ||
| MIN CABINET OPENING | |
| WIDTH | 2.50 |
| DEPTH | 14. |
| HEIGHT | N/A |
PRODUCT MAX WEIGHT RATING
| SLIDE SPECIFICATIONS | ||||
| SLIDE TYPE | BALL BEARING | SLIDE EXTENSION | 1/4″ O.T. | MAX WEIGHT RATING |
| SLIDE CLOSING | NORMAL | SLIDE LENGTH | 350 MM | |
| SLIDE MOUNTING | SIDE | SLIDE FINISH | 100 LB | |
This drawing is the property of Rev-A-Shelf (RAS) and is disclosed in confidence to the extent its subject matter is original to RAS. Any vendor receiving this drawing from RAS shall hold and use this drawing for the sole benefit of RAS and shall not disclose it to, or use or reproduce it for any third party, or perform any act adverse to the interest of RAS with respect to this drawing without the express written permission of RAS. Vendors shall not revise any physical, dimensional or performance characteristic unless authorized by Rev-A-Shelf Engineering.
Documents / Resources
 |
Rev-A-Shelf BRC-14CR_CUST Side Mount Belt Rack [pdf] Instruction Manual BRC-14CR_CUST Side Mount Belt Rack, BRC-14CR_CUST, Side Mount Belt Rack, Mount Belt Rack, Belt Rack |