Restore Solutions Containment Set Up
Specifications
- Brand: HEYWALL
- Product Type: Containment Kit
- Usage: Room division during renovation or maintenance work
- Features: Dust, dirt, and draft containment; Quick installation; Sealing rails for ceiling and walls
Product Usage Instructions
Installation Steps
- Open the carry bag and take out the extension system bars. Secure them to the footplates.
- Screw in the quick-release (spring-loaded) adaptor to the top section off the rod.
- Screw in the head plates where the plastic will be secured.
- On the head plate, pull back the locking flap to expose 2 holes underneath. Push up to lift the flap and lock in the plastic, then close the locking flap.
- To secure plastic against the ceiling, push the sealing rail into ceiling clips and push it towards the ceiling to lock the plastic in place.
- To install zippers, remove adhesive protection and stick the zipper to the plastic once erected. Open the zipper and use a knife to cut the plastic, making the zipper ready to use.
- To secure plastic against side walls, doorways, or openings, use the sealing rails with side clamps attached to extension system bars (ensure bars are 23cm-29cm for the wall to ensure the clamp will fit).
- Use Restore Solutions tape to secure the plastic where there are gaps allowing dust, dirt, or air to escape.
Outcome
After following these installation steps, you will have completed work without interruption to both the restorer/renovator and occupant in a safe environment. Additionally, you will have minimized clean-up efforts due to the environment for dust and dirt, leading to faster drying results by eliminating drafts.
Why Containment?
Containment kits are the best solution for dividing a room while work is taking place. This partition stops dust, dir,t, and drafts from entering spaces during refurbishment, renovations, restoration, and maintenance work, they can also be used to make small chambers inthe room to contain drying processes. The containment kit also ensures restricted access to the area whilst work is taking place.
How to
Installation Steps
- Open the carry bag take out the extension system bars and secure to foot plates.
- Screw in the quick-release (spring-loaded) adaptor to the top section of the rod.
- Screw in head plates (this is where the plastic will be secured).
- On the head plate, pull back the locking flap to expose 2 holes underneath, push up to lift the flap and lock in plastic then, close the locking flap.
- To secure the plastic against the ceiling, push the sealing rail into ceiling clips and push the sealing rail towards the ceiling locking the plastic in place.
- To install zippers, remove adhesive protection and stick the zipper to the plastic once erected. Open the zipper, then use the knife to cut the plastic, and then zipper will be ready to use.
- To secure plastic against side walls, doorways or openings use the sealing rails with side clamps attached to extension system bars (ensuring bars are 23cm-29cm for the wa\ll to ensure clamp will fit).
- Use Restore Solutions tape to secure the plastic where there are gaps allowing dust, dirt, or air to escape.
Outcome
Having completed work without interruption to both the restorer/renovator and occupant in a safe environment. Minimised clean up, due to the contained environment for dust and dirt etc. Faster drying results by elimination of drafts.
http:/restoresolutions.com.au
CREATING HEALTHY INDOOR ENVIRONMENTS
“On The Job” Industry Experience Since 1995
FAQ
Q: Can this containment kit be reused?
A: Yes, this containment kit can be reused multiple times for various projects as long as it is handled carefully and stored properly after each use.
Q: How do I know if the extension system bars are securely attached?
A: Make sure to tighten the screws properly when attaching the extension system bars to the footplates to ensure a secure fit before proceeding with further installation steps.
Documents / Resources
 |
Restore Solutions Containment Set Up [pdf] Installation Guide Containment Set Up, Set Up, Up |
