REMOTE PRO CS12E Control Board
Product Information
- The Ditec CS12E is a control board designed for use with compatible remotes to operate motorized systems such as gates or garage doors.
Specifications
- Model: Ditec CS12E
- Compatibility: Works with specific remotes
- Power Source: Coin/Button cell battery
- Manufacturer: Ditec
Product Usage Instructions
- Press and release the ENTER button on the motor. The screen will display AT.
- Use the up or down arrow buttons until the screen displays RO, then press ENTER.
- If SR is not displayed, use the arrow buttons to navigate until it shows up. Press ENTER.
- Press ENTER again, and SR will start flashing.
- Hold down the button on the remote for 2 seconds. The screen will briefly display OK before returning to SR.
- Press the ESC button to exit programming mode.
- Test the remote to ensure successful programming.
- This product may contain a coin/button cell battery.
- Keep the product and batteries out of reach of children.
- Ingesting a battery can cause severe or fatal injuries within 2 hours. Seek immediate medical attention if ingestion is suspected.
FAQ
- Q: How do I know if my remote is compatible with the Ditec CS12E Control Board?
- A: Please refer to the user manual of your remote or contact our customer support for compatibility information.
- Q: What should I do if the screen does not display SR during programming?
- A: Use the arrow buttons to navigate until SR is displayed, then proceed with the programming steps.
Programme your new remote
Programme your new remote into your Ditec CS12E Control Board
- Press and release the “ENTER” button on the motor and the screen will display “AT”.
- Press the up arrow or down arrow until the screen displays “RO” and then press “ENTER”.
- The screen should then display “SR” (if “SR” is not displayed, press the up arrow or down arrow until it does).
- Press “ENTER” and “SR” will begin flashing.
- Press and hold the button on the remote for 2 seconds and the screen will display “OK” briefly before going back to “SR”.
- Press the “ESC” button to return to exit out of programming.
- Test the remote.
WARNING
- This product may contain a coin/button cell battery.
- Keep products and batteries away from children.
- A battery can cause severe or fatal injuries in 2 hours or less if swallowed or placed inside any part of the body.
- Seek immediate medical attention if it is suspected that a coin/button cell battery has been swallowed or placed inside any part of the body.
Documents / Resources
 |
REMOTE PRO CS12E Control Board [pdf] Instructions CS12E, CS12E Control Board, Control Board, Board |