REMEMBER LD02 Table Lamp Piet Blau
Specifications
- Movable lamp head
- With E27 lamp socket
- With textile cable (1.5 m)
- With Euro plug
- Light switch integrated into cable
- Operating voltage: 230V
- Only suitable for indoor use
- Light bulb not included
- Light bulb max. 40W
- Dimensions: 35 cm, Ø 15 cm
Light Piet
Cable light
Application
Before commissioning, screw a standard household E27 light source with a maximum output of 40W into the lamp socket. Insert the mains plug into a mains socket (230V) and switch on the light using the light switch integrated in the cable.
Maintenance
To replace the light source:
- Disconnect the light from the power supply.
- Allow the light to cool down completely before removing the bulb.
- Ensure that the replacement bulb corresponds to the parameters of the luminaire in terms of type and wattage.
- Remove the old bulb and insert the new one.
Safety Instructions
Read the following safety instructions carefully:
- Please only use the appliance with the intended operating voltage of 230V.
- Caution! Parts of the appliance may become hot during use.
- Do not expose the device to excessive heat or cold.
- Do not expose the device to moisture.
- Do not drop the device.
- Not suitable for children.
- Do not disassemble, repair or modify the device.
- In the event of visible damage to the device, plug or cable, do not use the device and disconnect it from the power supply.
- Disconnect the lamp also from power supply if the device will not be used for a long time.
WEEE – Waste Electrical and Electronic Equipment Directive Waste electrical products should not be disposed of with household waste. You avoid environmental damage with the proper disposal.
The object of the declaration is in conformity with the Union harmonization legislation: https://www.remember.de/en/Declaration-of-conformity
FAQ
Q: What type of light source should be used with Light Piet?
A: Use a standard household E27 light source with a maximum output of 40W.
Q: How long is the cable of Light Piet?
A: The cable length is 1.5 meters of textile cable.
Q: Can I replace the light source myself?
A: Yes, you can replace the light source by following the maintenance instructions provided in the manual.
Documents / Resources
 |
REMEMBER LD02 Table Lamp Piet Blau [pdf] Instruction Manual LD_Leuchte_Piet_BDA.PDF, 240408_LD_BDA.indd, LD02 Table Lamp Piet Blau, LD02, Table Lamp Piet Blau, Lamp Piet Blau, Piet Blau |